- UVc Sterilizers
- >
- Evolution Aqua UV
- >
- Evolution Aqua evoUV 110 Watt Clarifier Sterilizer
Evolution Aqua evoUV 110 Watt Clarifier Sterilizer
Suitable for ponds UP TO 19,200 gallons for clarification (low bio-load/sunlight factor, 1/2 this size for high). This is dependent on stocking density and the amount of sunlight the pond is subject to.
A max flow rate of 9,600 gallons per hour (we recommend under 6,600 gph for best results).
Suitable for ponds, aquariums, or aquarium systems up to 3300 gallons for level one or even level two sterilization (dependent on other factors such as turnover, stocking, etc.) with a suggested max flow rate of 3300 gallons per hour.
Individually chambered lamps for optimum efficiency and contact time.
Fused quartz glass sleeves which ensure that germicidal lamps are able to reach their optimum 'burn temperature' where the highest amount of UVC radiation is emitted. Also facilitates simple lamp replacement by keeping lamp separate from the pond water.
Can be connected to either flexible or rigid plumbing using the appropriate plumbing fittings (not supplied). To ensure unrestricted flow, it is recommended that the unit is not plumbed in with anything less than 1-1/2” pipe work
Can be used for pressurized systems up to 43.5 psi
Easily wall mountable
Very durable heavy duty PVC construction
Approximately 40 inches long X 15 inches wide x 4 inches high (102 cm x 38 cm x 10 cm)
Flow is non-directional, either port can be used for inlet or outlet
New generation long-life electronic ballast that is also easily replaced (see TMC Replacement Ballasts)
Supplied complete with a 5m cable and a 24 month guarantee
---
Flow Calculations for how we arrive at our flow and aquarium size calculations.
We go by these calculations NOT what any manufacture claims on their box! In the case of many other manufactures, they tend to over rate their UV clarification abilities. While for Sterilization, tends to rate the tank size for level two Sterilization (albeit a little high here as well), NOT level one!
On most UVs these numbers which, while not perfect, and assume a few parameters such as low water turbidity and proper spacing between lamp/sleeve & inside wall of the UV, has proven over the years to be highly accurate for the author of the above cited article (Carl Strohmeyer). For us to change this formula to fit certain manufacturer sizing recommendations as some have asked would be highly dishonest for us to do.
Flow rates are based on actual flow rates after Head Pressure is factored in.
Note: We check all UV prior to shipping and pack units well. Consider using Standard Shipping for guaranteed shipping service. We also offer inhouse service of the UV for the life of the unit. If there's ever an issue you cannot figure out... email us and we can help or if you want us to handle the service, just send it to us. Only cost to you is shipping and parts. We'll pay shipping back!
We do not recommend using surge protectors or multiplugs as this can limit the surge needed to strike low pressure HO UV Lamps.
Our professional experience has shown these are the best designs for aquarium and pond clarification or sterilization. With the correct flow rate and body size of water the UV can achieve clarification, level 1 and level 2 sterilization. All while boosting immunity of fish and life in the water. For best disease prevention!
Up to bacteria, virus, and parasite control.
See our Sterilization Article for indepth info on clarification and sterilization:
Sterilization Article
With a T8 long lamp design. Keeping the water close to the UV rays for a long period of time. Professional commercial grade with easy serviceable parts.
A low energy, electronic ballast is positioned in a fully serviceable, showerproof compartment, with thermal overload protection. The evoUV is simple to install, with universal mounting plates allowing you to fix the unit horizontally or vertically, or at any angle you choose. Your evoUV professional quality UV can be connected to a pump or power filter with flexible hose using the hosetail provided, or you can install the unit using hard pipe. It is suitable for use as part of full pond system after filtration and sump based aquariums, external power filters or pump fed closed loops.